In this panel, you can adjust the offsets of your holder or use offsets of a predefined one:
- Your Sensor: the current offsets for your holder.
- Indianagio Front: BLTouch support made by Giorgio Baseggio (Indianagio)
- Teaching Tech L. Side: BLTouch support made by Michael Laws (TeachingTech)
- Mark II: Support for the Mark II sensor.
To use one of the predefined holder, use the left and right arrow buttons. You can adjust the offset if you like and press the Checkmark button to save the offsets.You can also manually enter the offsets if you know them. For the Z axis, you can also use the Z-height Panel to determine it.
New in version 5.5: If you have a BLTouch, you can select the High speed option to speed up the automatic bed leveling. Instead of deploying and stowing the probe's pin for each measurement, it will stay deployed.
If you use a custom holder that is not in the list of predefined ones, you can measure and enter the X and Y offsets:
- If the sensor is on the left of the nozzle, the X offset is negative.
- If the sensor is on the right of the nozzle, the X offset is positive.
- If the sensor is in the front of the the nozzle, the Y offset is negative.
- If the sensor is in the back of the nozzle, the Y offset is positive (this is unlikely because there is no room).